Monster Mill MM-2 Homebrewer 2-roller Mill, with 3/8" drive shaft

It consists of a 6061 aluminum block frame with two 6" long steel rollers riding on SAE 841 oil impregnated bronze bushings. The superior grade of steel is much harder than what is found on most comparable products and should last almost twice as long. The drive shaft, and all the axles are integral to the roller rather than screwed into the ends. This makes it fine to drive the mill clockwise, or counter-clockwise. All the axles are 3/8", with minimal freeplay in the bushings. 

One of the knurled steel rollers is driven by a standard 3/8" electric drill (not included) to feed the grain through the adjustable gap and crush the grist. Both ends of the non-driven roller ride in bushings that are offset mounted in an adjustable knob. The knob is held in a fixed position by a set-screw that you can loosen to adjust the mill. This system provides an adjustment range of .070". The knobs are made from 303 stainless steel for excellent durability, and are knurled for a positive grip. A groove in the knobs with a matching rounded head on the thumbscrew allows for a much better grip on the knob to avoid gap changes while milling, and also providing knob retention.

Plain steel mills kept indoors, and used regularly won't have rust issues. Non-climate-controlled areas or minimal usage could see some corrosion come up that is easily removed with a wire brush.  The Monster Mill MM-2 is NOT recommended for any commercial operation, brew shop, brewery etc.  This mill will NOT mill corn.  It is designed for barley and wheat malt, rye, and unmalted wheat. For corn see the 2Pro mill (65612-HT).  For all commercial applications, check out the 3-Pro professional Monster Mills with HEAT-TREATED steel rollers (65613-HT).  Heat treated rollers last 10X as long as regular or stainless steel.

6" Long Adjustable Gap:

• fully adjustable mill
• dual eccentric adjusters: 0 to .070" gap - built from STAINLESS STEEL for no galling
• 6 lbs / minute
• 6" upgraded steel rollers
• drill-drive - CW, OR CCW
• alloy frame
• SAE 841 oil impregnated bronze bushings
• 1.5" diameter steel rollers
• 3/8" integral axles
• 3/8" drive shaft with 3 flats for perfect attachment to your 3/8" chuck drill, 2" long outside frame
• 1144 alloy steel rollers standard