Polylam Capsules - Matte Black, 29.5 x 55mm, case of 5000

How to check the fit of a polylam capsule on your bottles:

Drop the polylam over the neck. Place your finger on the top and make sure the capsule has bottomed out. Give it a slight wiggle. The correct fit will bottom out and you will get a very slight movement back and forth.

The Polylaminate material is very malleable, but it is not as soft as tin. The spinner equipment and rollers need to be in good working condition to achieve a smooth look on the bottle. In addition, certain bottles finishes with aggressive drip beads might be challenging for the Polylaminate material properties.

A few tips for proper Polylaminate capsule application:

• Make sure all of the spinner rollers are clean and free of defects. For best results, the spinner should berotating clockwise (viewed from the roller side) at approximately 1200 rpm.
• The bottle should enter the spinner completely centered and perpendicular to the rollers.
• When using a bench top spinner, insert and remove the bottle slowly (3 seconds in and 3 seconds out).
• Check the spinner bands for wear and adjust for more tension to eliminate wrinkles, less tension to eliminate tearing.